GPR consult

Razprave o najrazličnejših razpisih ...
Locked
amebica
Posts: 44
Joined: 20.6.2013 7:47

GPR consult

Post by amebica » 23.1.2014 9:05

Lp!
Prosim, ima kdo kake informacije o tej firmi kdo so, kaj so, za kaj so, kaj delajo. od kod prijhajajo ,kam gredo?

Hvala!

User avatar
stream
Posts: 312
Joined: 21.3.2006 0:39
Contact:

Re: GPR consult

Post by stream » 4.3.2015 8:47

Nobeden ne ve o njih se pravi nevem, če kam gredo.

Roman
Posts: 6342
Joined: 21.10.2003 8:03

Re: GPR consult

Post by Roman » 4.3.2015 10:38

Ti to kaj pomaga:
http://frankfurtnet.com/index.php?optio ... &Itemid=27?

(osnovno pravilo v časih interneta: če ne veš, vprašaj strica Googla)

User avatar
stream
Posts: 312
Joined: 21.3.2006 0:39
Contact:

Re: GPR consult

Post by stream » 4.3.2015 13:04

amebica wrote:Lp!
Prosim, ima kdo kake informacije o tej firmi kdo so, kaj so, za kaj so, kaj delajo. od kod prijhajajo ,kam gredo?

Hvala!
No sedaj pa res vse lepo piše, hvala.

User avatar
stream
Posts: 312
Joined: 21.3.2006 0:39
Contact:

Re: GPR consult

Post by stream » 3.10.2019 10:11

"This tool uses a 0° reference. This means when a board is squared off the tool reads 0°.The angle derived is actually a complementary angle. For example a 22.5° angle is actually 67.5°. The sum of the angles equals 90 degrees(22.5° +67.5°= 90°). It is obvious from a visual check that where the instruments displays 22.5° is not 22.5°. Many of the new slide miters and miter boxes display both angles. Some of the new calculators have a 0° and a 90° references to do angular calculations. This can create much confusion if the user does not understand this angular calibration."

Tole dobiš iz moje zaloge z dostavo nevem niti kam zdaj.

Locked